You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
Yeah I know it's the Engine Fuel Pressure Regulator. Saab ran a test it was good. What could have triggered this code. Ran the gas tank too low, bad or not enough clicks on the fuel cap??
Diagnostic trouble code P0089 - The ECM commands the Bosch high-pressure fuel pump to deliver a specific fuel rail pressure - that can vary up to 23,000 psi depending on load and speed. The actual pressure is monitored via the fuel rail pressure sensor. If the fuel rail pressure varies more than desired or if commanded fuel pump flow is 100mm3/second or less, DTC P0089 will set.Corrective action includes measuring the fuel rail pressure using a Tech II scan tool, then compare that to commanded fuel rail pressure with the engine running at 2000 rpm. The difference must be less than 20 Mpa.A blockage in the fuel tank or plugged fuel filter could cause this fault (excessive vacuum in fuel line). If there is less than 5 in Hg of vacuum when measured at the fuel pressure test port at 3000 rpm, the fuel pressure regulator could be defective, and may need to be replaced. The fuel pressure regulator (FPR) is a sub ***embly located on the Bosch high-pressure fuel pump.
CODE P0089
