Opinions??? P1300 and P1301 CEL codes
#1
Opinions??? P1300 and P1301 CEL codes
Looking for opinions from you skilled knowledge-heads.
I have a 2002 9-3 SE 5 speed with 138k and recently it has been having two symptoms: (1) on a cold start it sometimes turns over fine, idles, and then starts dropping RPMs as if it's going to stall but it does not stall (it doesn't happen once the car is warm). (2) Between 2,700 RPMs and 3,500 RPMs the same "stuttering" sensation occurs under acceleration. No fault codes have come on until yesterday.
When driving the car hard last night the CEL began blinking. The car was shut off and restarted. The light did not come back on. I had the codes read today and they are P1300 and P1301. I'm assuming the two issues the car has been having are related to these fault codes.
Does anyone have input? Ideas? Suggestions? It is SO MUCH APPRECIATED!!!!!!
I have a 2002 9-3 SE 5 speed with 138k and recently it has been having two symptoms: (1) on a cold start it sometimes turns over fine, idles, and then starts dropping RPMs as if it's going to stall but it does not stall (it doesn't happen once the car is warm). (2) Between 2,700 RPMs and 3,500 RPMs the same "stuttering" sensation occurs under acceleration. No fault codes have come on until yesterday.
When driving the car hard last night the CEL began blinking. The car was shut off and restarted. The light did not come back on. I had the codes read today and they are P1300 and P1301. I'm assuming the two issues the car has been having are related to these fault codes.
Does anyone have input? Ideas? Suggestions? It is SO MUCH APPRECIATED!!!!!!
Thread
Thread Starter
Forum
Replies
Last Post