So heres the thing, I am a heavy equipment mechanic.......So I thought I could tackle this new clutch install no problem in my garage with no hoist............man was I in for a surprise.

So I pull the motor and trans, have the flywheel turned and install the new clutch put everthing back together...blah...blah......

Anyways I go to start the car and I have nothing, all the lights come on but no click.
I had to remove the battery tray and the remove the all the 12v leads on the juntion box, could I have wired that wrong?


After I had worked on the car for 2 days straight and It didnt start......well to be honest I just shut the hood an pushed it out side and havent touched it since.......so it could very well be a very simple problem...............now I think I have calmed down enough to try again...

Any Ideas??????


Thanks
Phil

 

I'm not usre how the old 9000s have the wiring set up, but take a multimeter and check if there is power at the starter relay.